In the case of the Temperature Power Sensor and High Temperature Thermostats

Because our products are used for temperature control, the model numbering system is slightly different from the numbering of protectors.
(Model designation method 1) In the case of the TPS


(Model designation method 2) In the case of the TPS


(Model designation method) In the case of the High Temperature Thermostats


•Model name
Please make sure to leave a space after the model name to avoid confusion between the model name and the operating temperature

•Operating temperature
TPS(within a range of -10~110°C)
High Temperature Thermostats (within a range of 150~400°C)
(Preset temperature include some tolerance)

•Configuration of contacts
X: Contacts will open when a temperature goes up
X(bar): Contacts will close when a temperature goes down
Y: Contacts will close when a temperature goes up
Y(bar): Contact will open when a temperature goes down
Note: X and X(bar) are exactly same product.
In case of an accurate temperature control is necessary when a temperature goes up, specify X.
In case of an accurate temperature control is necessary when a temperature goes down, specify X(bar).
Specify Y and Y(bar) with the same method.

Please see the following diagram with contact configuration, operation temperature and temperature factors

MQT8H K35XC represents a thermostat with crossbar contacts (K means crossbar contact).
For 5 Amp. Series with a back contact, a model name will be, for example, M3 70XZB, where Z means contact with the back contact.
Above diagram also shows you an operation of thermostat with back contact Y/Y(bar) type, the open/close will be opposite in case of X/X(bar).

•Differential rank (in the case of the TPS)
A(3±1), B(4.5±1.5), C(6.5±1.5), D(10±2)
Matsuo thermostat standardizes C for X/X(bar) contacts and B for Y/Y(bar) contacts.
Please carefully specify the differential ,if necessary, since the maximum current will be reduced in accordance to a specified Differential.
Please see PDF for 2 amp • 5amp series.

Guidelines for Ordering. Please state the following when you order
1. Model name
2. Quantity
3. Setting temperature and setting tolerance
4. Differential (ON/OFF temperature difference)
5. Contact configuration [ X, Y, X(bar), Y(bar) ]
6. Load capacity and type
7. Rate of change of ambient temperature and wind velocity, etc.
8. Power supply voltage and AC or DC
9. Other information such as applications, operating conditions, etc. in as much detail as possible.
The more precise, the better we will be able to serve you.

Matsuo is pleased to accept your order without Model , simply tell us your application so that we can specify an appropriate thermostat.
Please contact our sale for further information.

In the case of the Electronic Thermostat (MET series)

(Model designation method 1) In the case of temperature variable type


(Model designation method 2) In the case of temperature fixed type

In the case of the Disk Type Thermostats

(Model designation method)

1. Shipment : F.B.O. Tokyo in Japanese yen.
2. Payment : Full payment on order.